Canine coronavirus (CCV) is a highly infectious virus in the intestine of dogs, especially puppies. CCV is usually short-lived but may cause considerable abdominal discomfort for a few days in infected dogs.
The RIDX^® CCV Ag Test Kit is a lateral flow chromatographic immunoassay for the qualitative detection of CCV antigens in canine feces. This kit shows two letters which are the test (T) line and the control (C) line on the surface of the device. If the CCV antigen exists in the sample, it binds to the gold-conjugated CCV antibody. The antigen-antibody complex moves through the membrane by capillary force and responds to the CCV antibody on the test line, resulting in a red line. The control line indicates that the test is performed correctly and should appear when the test is complete.
The highly selective and sensitive monoclonal antibody to CCV is used as a capture and detector in the kit. The RIDX^® CCV Ag Test Kit can detect CCV antigens in canine feces with high accuracy.

Canine feces

• RIDX CCV Ag test device (10 or 2 tests)
• Sample dilution buffer (10 or 2 vials)
• Disposable swab (10 or 2 ea)
• Disposable dropper (10 or 2 ea)
• Instructions for use (1 sheet)

• Sensitivity: 94.9% (56/59) vs. RT-PCR
• Specificity: 97.5% (118/121) vs. RT-PCR
• Diagnostic Agreement: 96.6% (174/180) vs. RT-PCR
• Limit of Detection: 1x10⁵ TCID₅₀/mL
• No cross-reactivity with other canine pathogens (CDV, CIV, CPV, Escherichia coli, Giardia, and Salmonella)

• 10 Tests/Kit [CGM-CCG-11]
• 2 Tests/Kit [CGM-CCG-12]

1. All reagents and samples must be at room temperature (15~30℃/59~86℉) before use.
2. Collect fecal samples using a swab.
3. Put the swab into the sample dilution buffer and stir the solution with the swab to disperse the sample into the buffer (approximately 10 seconds).
4. Remove the swab from the sample dilution buffer.
5. Wait for 20 seconds to settle down the large particles.
6. Remove the test device from the pouch and place it on a flat and dry surface.
7. Take the supernatant of the sample solution in the tube by using a disposable dropper.
8. Apply 4 drops of the sample solution into the sample hole (S) on the device, drop by drop vertically.
9. Read test result at 10 minutes.